Lighting Controller :: Part 3

I got the components mounted on the main and remote boards. After much deliberation we dropped $12 per remote node to pick up some waterproof plastic ammo boxes to put the electronics in. These boxes will be out in the yard exposed to snow/rain. The boxes worked out very well, as the 3-gang outlet box fit nicely inside. Just drilled a hole in the bottom so the cords can go in/out.

Wiring up the outlets was pretty easy. Common wire was shared across them all, and the hot (black) wire was sourced from the circuit board (triac). I did not use any ground wire as the Christmas light strings don’t have ground. I also used a pretty light gauge wire as I will only be driving a single string of LED lights per outlet.

WP_20121202_003
WP_20121201_004
WP_20121201_002

Got everything wired up at the neighbors and everything worked well. Even with 100′ cat5 runs to some of the remote boxes everything worked well. We did have some flakeyness where it would lock up occasionally after a few hours. I upgraded the wallwart power supply to an old computer supply, and at the same time fixed a solder joint for the ground wire that looked ‘cold’. Not sure which of the two upgrades fixed the issue, but all is good now.

Below is a picture of the main controller board wired up on the workbench. Will post a video of the light show in the next update!

xmas controller

One thing you may notice is the FTDI controller connected via USB. This is due to the fact the Arduino Mega changed the way they emulate usb/serial. This new chip on the arduino is not identified by the software running the lighting show (Vixen). Using an older-style FTDI board remedied that situation…

Leave a Reply

Your email address will not be published. Required fields are marked *